Loading... Please wait...

Grove 128x64 I2C OLED Board for Arduino and Raspberry Pi

Hover over image to zoom

  • Image 1
  • Image 2
  • Image 3
  • Image 4
  • Image 5
  • Image 6
  • Image 7
  • Image 8
SwitchDoc Labs
$14.45
SKU:
0070-GRVOLED128x64-DSBT
Current Stock:
50

 Product Description

This is a very readable Grove 4 Pin Connector I2C OLED module. Due to the high contrast of an OLED display, it is readable even at small fonts. This display is made of 128x64 individual white OLED pixels, each one is turned on or off by the controller chip. Because the display makes its own light, no backlight is required. This reduces the power required to run the OLED. This breakout is used with an I2C interface. The design is completely 3.3V/5V-ready, with an onboard regulator and built in boost converter. Connects to either Arduino or Raspberry Pi controllers with no level shifters required. No Grove Cable included. No external reset pin required. Software drivers are available here.

This is an inexpensive I2C OLED display using Grove Connectors for the Arduino / Raspberry Pi / ESP8266

This product is a very flexible Grove 4 Pin Connector I2C OLED module. This display is a 128x64 OLED, with each pixel being turned on or off by the SSD1306 controller chip included in the module. You can display fonts, graphics and even animations with this crisp, high contrast display.

What are Grove Connectors?

Grove Connectors are standardized easy to connect and use cables for prototyping devices.   See the SwitchDoc tutorial on Grove Connectors. This product was designed specifically for the new SwitchDoc Labs kickstarter, OurWeather: https://www.kickstarter.com/projects/sunair/ourweather-weather-kit-for-stem-kids This breakout is designed to be used with a Grove I2C Connector. The design is completely 3.3V/5V-ready, with an onboard regulator and built in boost converter. Connects to ESP8266, Arduino or Raspberry Pi controllers with no level shifters required. No Grove Cable included. No external reset pin is required. We have a power-on reset circuit on board. The board is trivial to connect up to your system.   Plug it into a 5V or 3.3V Grove connector on your Raspberry Pi, Arduino or ESP8266 and you are ready to go.   The I2C address used is 0x3C (not 0x3D as some other displays).   The SSD1306 specification can be downloaded here.

Downloads

 Find Similar Products by Category

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...

 

What's News

newsletter

Copyright 2017 SwitchDoc Labs. All Rights Reserved.
 Sitemap

Click the button below to add the Grove 128x64 I2C OLED Board for Arduino and Raspberry Pi to your wish list.